Advertisement  
   Forum Home CyberPT Home Page      
Forum Home Forum Home > Patient Forum > Lower Extremity & Knee Injuries/Conditions
  New Posts New Posts RSS Feed - arthritis behind the knees
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

arthritis behind the knees

 Post Reply Post Reply
Author
Message
Ask a PT View Drop Down
Senior Member
Senior Member
Avatar

Joined: Jul 07 2008
Status: Offline
Points: 954
Post Options Post Options   Thanks (0) Thanks(0)   Quote Ask a PT Quote  Post ReplyReply Direct Link To This Post Topic: arthritis behind the knees
    Posted: Jun 04 2010 at 1:28pm
Our user asked: "I have been told by a very good doctor that I have arthritis behind my knees. He told me a couple exercises to do with my knees...like doing leg lifts...about 6 inches off the floor, and also told that an elliptical machine would be good. He did say that walking would be good, too. When I asked if bicycling was good, he said yes, but to not bend the knees alot. I have the seat on my bike fairly high ( I have to lean the bike to the side in order to get on it) but I am not sure if I'm bending my knees too much. Why is it not good to bend the knees? Can you tell me more exercises and reasons for not bending the knees?"
 
Ask a PT Response: "The more you bend your knees while cycling, the more force you are putting through the knee joint. With a knee bent too much, this can be too aggressive for someone with osteoarthritis. If you take a look at the anatomy of the knee, when the knee is extended/straight in standing the femoral condyles (end of thigh bone) have maximal contact on the tibia (top of the lower leg bone) and allows for a greater surface area for the distribution of forces. However, as the knee goes into flexion/bending, the area where forces can be distributed becomes smaller and results in added stresses to a smaller focused area on your femoral condyles. This added stress to a focused area could result in further damage to the cartilage of an individual who is already suffering form osteoarthritis.
 
As far as biking goes, according to a new study by Willard Peveler, Ph.D., of the University of Central Arkansas, properly dialing in your saddle by the angle of your knee can maximize cycling efficiency. The ideal angle for cycling, Peveler found, is a 25-degree knee bend when the crank arm is in a 6 o'clock position. You can also check out this article on "Saddling up a Proper Bike Fit" to make sure you have proper, safe setup for bicycling: http://www.therapytimes.com/content=5801J64E489EBC841. I hope this helps."
Back to Top
Sponsored Links


Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.03
Copyright ©2001-2015 Web Wiz Ltd.

This page was generated in 0.203 seconds.